Priority Control: Reset Overrides Enable Overrides Load
A counter can be told to reset, load and count all in the same cycle. The order of your if/else branches decides which command wins.
This module is an 8-bit counter that enforces a strict priority hierarchy among its control signals. When the enable signal is asserted, the counter increments by 1. When the load signal is asserted, the counter loads the value from the data input. If neither is asserted, the counter holds its current value. If both enable and load are asserted simultaneously, the enable signal takes priority and the counter increments, ignoring the load command.
Timing and Reset Rules:
- Clock edge:
posedge - Reset type: Asynchronous
- Reset polarity: Active-low
- Output values on reset:
countgoes to8'b00000000 - Priority hierarchy: Asynchronous
rst_noverrides synchronousen; synchronousenoverrides synchronousload.
Worked Trace:
- Cycle 1:
rst_n=0 →count=0 (Reset overrides all) - Cycle 2:
rst_n=1,en=0,load=1,data_in=10 →count=10 (Load operation) - Cycle 3:
rst_n=1,en=1,load=1,data_in=20 →count=11 (Enable overrides load) - Cycle 4:
rst_n=1,en=0,load=0,data_in=20 →count=11 (Hold value) - Cycle 5:
rst_n=1,en=0,load=1,data_in=55 →count=55 (Load operation) - Cycle 6:
rst_n=1,en=1,load=0,data_in=55 →count=56 (Increment operation) - Cycle 7:
rst_n=0,en=1,load=1,data_in=99 →count=0 (Reset overrides all) - Cycle 8:
rst_n=1,en=0,load=0,data_in=99 →count=0 (Hold value)
| Signal | Direction | Width | Description |
|---|---|---|---|
clk |
input | 1 | Positive-edge triggered clock |
rst_n |
input | 1 | Asynchronous active-low reset; drives count to 0 |
en |
input | 1 | Enable; increments count by 1 on posedge clk |
load |
input | 1 | Load; sets count to data_in on posedge clk when en is 0 |
data_in |
input | 8 | Data to be loaded into the counter |
count |
output | 8 | Current counter value |
Constraints
- Clock edge must be positive.
- Reset must be asynchronous and active-low.
- Output must be exactly 8 bits wide.
- Enable must override load when both are asserted simultaneously.
- Counter must wrap back to 0 automatically when incrementing past 255.
Topics
Solve this problem
Write the module in Verilog, SystemVerilog or VHDL. Your submission is compiled and simulated against the problem's testbench. You get the waveform back, not a stored answer.
This problem is part of Codiode Pro. The statement above is free to read.
The circuit builder and code editor need a desktop screen. On a phone, read the problem here and open it on a laptop to solve.
Part of Sequential RTL
Problem 11 of 26 in the Sequential RTL track.
Related problems
Browse all problems · Verilog practice problems · Learning tracks