Codiode

Unconnected Input Ports

EasyLogic CircuitDebug

An alarm control module outputs a trigger signal when a sensor detects an event or a manual override is pressed, provided the entire system is enabled.

Expected behavior:

EN SENSOR OVERRIDE ALARM
0 0 0 0
0 0 1 0
0 1 0 0
0 1 1 0
1 0 0 0
1 0 1 1
1 1 0 1
1 1 1 1

Simulation shows ALARM = X for input EN=1, SENSOR=1, OVERRIDE=0. The output propagates an unknown state instead of asserting the alarm. Inspect the circuit and correct the fault.

Constraints

  • Do not add or remove any logic gates.
  • Only add the missing wire connection to resolve the floating input.

Topics

combinational-logicdebuggingwiring

Solve this problem

Place the gates, wire them up and watch the signals settle. Every submission runs on the same simulation engine that grades it.

This problem is part of Codiode Pro. The statement above is free to read.

The circuit builder and code editor need a desktop screen. On a phone, read the problem here and open it on a laptop to solve.

Part of Gate-Level Logic

Problem 52 of 62 in the Gate-Level Logic track.

Related problems

Browse all problems · Digital logic design practice problems · Learning tracks

Solve this on a laptopSend yourself the link and continue there.