Codiode

Ripple Counter: Q2 Stuck-at-0 Fault Debug

HardLogic CircuitDebug

A 4-bit ripple counter generates a sequential binary count from 0 to 15 on each clock pulse.

Expected behavior:

CLK pulses Q3 Q2 Q1 Q0
0 0 0 0 0
1 0 0 0 1
2 0 0 1 0
3 0 0 1 1
4 0 1 0 0
5 0 1 0 1
6 0 1 1 0
7 0 1 1 1
8 1 0 0 0

Simulation shows the count sequence jumps incorrectly. After reaching 3 (0011), the next clock cycle produces 0 (0000) instead of 4 (0100). The observed decimal sequence is 0, 1, 2, 3, 8, 9, 10, 11. Bit Q2 remains permanently at 0, while Q3 continues to toggle correctly.

Inspect the circuit and correct the fault.

Constraints

  • Do not add new flip-flops or replace the entire counter architecture.
  • You may only modify wiring, connections, or fixed logic levels driving the existing flip-flops.

Topics

DebuggingSequential LogicCountersStuck-at Fault

Solve this problem

Place the gates, wire them up and watch the signals settle. Every submission runs on the same simulation engine that grades it.

This problem is part of Codiode Pro. The statement above is free to read.

The circuit builder and code editor need a desktop screen. On a phone, read the problem here and open it on a laptop to solve.

Part of Counters

Problem 10 of 139 in the Counters track.

Related problems

Browse all problems · Digital logic design practice problems · Learning tracks

Solve this on a laptopSend yourself the link and continue there.