Codiode

Ring Counter: Wrong Feedback Stage Debug

MediumLogic CircuitDebug

A 4-bit ring counter circulates a single active bit through a series of flip-flops to create a sequential timing sequence.

Expected behavior:

rst Q3 Q2 Q1 Q0
1 0 0 0 1
0 0 0 1 0
0 0 1 0 0
0 1 0 0 0
0 0 0 0 1
0 0 0 1 0

Simulation shows the counter entering an incorrect sequence. After initialization to 0001, the next state is 0010, but the following state evaluates to 0101. The counter then oscillates between 0101 and 1010. The expected period of 4 is not achieved.

Inspect the circuit and correct the fault.

Constraints

  • Do not add or remove any flip-flops.
  • Modify only the incorrect wire connection causing the sequence failure.

Topics

DebugSequential LogicShift Registers

Solve this problem

Place the gates, wire them up and watch the signals settle. Every submission runs on the same simulation engine that grades it.

This problem is part of Codiode Pro. The statement above is free to read.

The circuit builder and code editor need a desktop screen. On a phone, read the problem here and open it on a laptop to solve.

Part of Counters

Problem 94 of 139 in the Counters track.

Related problems

Browse all problems · Digital logic design practice problems · Learning tracks

Solve this on a laptopSend yourself the link and continue there.